Registering or Unregistering a Sensor

If you have a Rhombus Systems Sensor, registering it takes just a few quick steps:

• T1 Asset Tag
• D1 Door Sensor
• E1 Environmental Sensor
• E2 Environmental Sensor
• M1 Motion Sensor
• Unregistering a Sensor

First, you must have an R2/R200 camera within range (50 feet or less from sensor) and the R2/R200 must already be registered and powered on. You must also have the mobile app (Android or iOS) installed on your phone as registration can only be done from the mobile app.

T1 Asset Tag

To register this sensor, press down on the back of the sensor on the black dot after the word "contains" to put the sensor in registration mode. You will see a green dot pulsing once the sensor is ready to be registered (as seen below). The sensor will stay in registration mode for 2 minutes before going to sleep. 

Once the green dot is pulsing, open your mobile app and select "Register Devices". From there select the devices you want to register and that is it.

You can register as many sensors at once as you want.

D1 Door Sensor

To register the door sensor, touch the magnetic contact portion of the sensor to the door sensor to activate it for registration. When you touch the two, you should see a green light pulsing which means it is ready to register (as seen below). The sensor will stay in registration mode for 2 minutes before going to sleep.

Once the green dot is pulsing, open your mobile app and select "Register Devices". From there select the devices you want to register.

E1 Environmental Sensor

To register the environmental sensor, insert the included tool or a paper clip to activate it for registration. When you insert it, you should see a green light pulsing which means it is ready to register (as seen below). The sensor will stay in registration mode for 2 minutes before going to sleep.

Once the green dot is pulsing, open your mobile app and select "Register Devices". From there select the devices you want to register and that is it.

E2 Environmental Sensor

To register the E2 sensor, power it on via MicroUSB connection, and open up the Rhombus mobile app. Select "Register Devices". From there select the "Sensors" button to register the device with BLE.

M1 Motion Sensor

To register the motion sensor, insert the included tool or a paper clip to activate it for registration. When you pull the battery tab, it will automatically put the sensor in registration mode so this is not necessary if you immediately register it after pulling the tab.

When you insert it, you should see a green light pulsing which means it is ready to register (as seen below). The sensor will stay in registration mode for 2 minutes before going to sleep.

Once the green dot is pulsing, open your mobile app and select "Register Devices". From there select the devices you want to register and that is it.

Unregistering a Sensor

You can unregister sensors from the phone app. You will need to be connected to the same network as the sensor you want to un-register.  

Here are the steps:

1. Home page by clicking on 'Devices'

2. Scroll to the bottom and click 'Utilities'

3. Click on 'Unregister Sensors'

4. Select the sensors you want unregister and continue the process