Once you have unboxed an R1 camera, there are a few ways to wire it depending on what configuration you choose. Below outlines each of the steps.
Power over Ethernet (PoE)
This method is by far the simplest, where all that is necessary is to place the ethernet cable into the back of the camera. The cord will provide both the power (assuming you have a proper PoE injector) and the internet connectivity.
For this configuration, simply plug an ethernet cord into the back of the camera and the other end into the power adapter. The supplied power adapter also acts as the WiFi antenna.
Ethernet + Power
If you are using a standard ethernet connection without power, then you'll need to use the included cable adapter. The yellow cable should be plugged into the supplied power adapter and the white cable should go to your router. The other side of the adapter labeled "Camera" goes into the camera.
If your cameras are being mounted outside, it's very important to insert the cable using the rubber plug (grey plug below) and the cap (item to right of plug). The plug should have a small slit in it where you can open it to insert the cable. Also, it's very important to have a water loop in the cable as discussed in this article. See the pics below.
Next - Mounting your Camera